How A Pool Lift Chair Mechanism Installation Works

man using a pool lift chair after lift chair mechanism installation

If you own or manage a business pool or spa, such as a swim club, hotel, or resort, the Americans with Disabilities Act (ADA) mandates the installation of a pool lift to help persons with disabilities. Let’s learn more about lift chair mechanism installation. 

You may start installing the pool lift once you’ve chosen your installation site. Each pool lift has its own set of criteria. So, make sure you know how each type of pool lift works before purchasing one. 

pool lift chair ready for use after lift chair mechanism installation

Retrofitting or Installing a New Pool Lift 

The installation requirements will vary depending on the kind of pool lift you choose. A single post slips into an anchor socket on certain lifts. Other lifts feature a ‘Jig’ plate with three or four bolts protruding from the concrete. 

Using a hole saw and epoxy, many pool lift types may be retrofitted. Drill numerous big holes in the pool deck, then fill the gaps with 2-part epoxy sealant to bind the mounting plate to the deck. 

This hole saw installation is complex because the mounting plate or anchor socket must be glued under local laws. 

Pouring a Lift Pad for a Pool 

A jig is required for some pool lifts, which must be built in extra-thick concrete (6-8 inches thick). Because most pool decks are just 4 inches wide, you’ll need to mark out the required area and cut it off using a concrete saw. Remove the rubble by breaking it up with a sledgehammer or jackhammer. 

Remove the gravel and dig 4-8 inches down (be careful of pipes and conduit). Install four rebar rods two inches from the bottom of your slab and four more two inches from the top, going in opposite directions. If feasible, attach the rebar to the existing deck and your mounting plate to the grid. 

Place your bonded mounting jig or post anchor into the cement bed at the proper time and depth. Pour concrete until it reaches the desired thickness. While curing, keep the jig level. Finish the surface by feathering up to the jig or post’s edge. 

Getting Your Pool Lift Bonded 

Most places will require that the pool lift be connected to the pool’s bonding grid, which is a bare copper wire that goes around the pool and connects the pool shell, lights, ladders, and rails. 

In most situations, the mounting jig or post anchor will come with a bonding lug that must be linked to an existing bonding loop, or the mounting plate may be bonded to the pool deck rebar grid. 

Connecting the bonding wire to a pool lift post or jig with a hole saw may need some imagination and involve running under the deck to the edge. In contrast, it is quicker to make the bonding connection if you remove the old pad and replace it with a new pad. 

If a proper connection is required, an electrician knowledgeable with local bonding standards for swimming pools should be contracted or employed.

lift chair mechanism installation successfully done

Want to Know How a Pool Lift Chair Mechanism Installation Works? 

Here are some useful tips to keep in mind before you buy a pool lift: 

  1. Make sure you have a suitable site in mind. 
  1. Before you buy a pool lift, make sure you read the installation manual thoroughly. 
  1. In compliance with local and national norms, plan to bond the elevator. 

As an installation guide, these are a few essential takeaways for lift chair mechanism installation. Finally, it’s a good idea to verify with your local county official or inspector before installation to ensure that your site, installation, and bonding are all approved. 

If you need someone to do all the heavy lifting, call Pool Lift Specialists. We can help you install any type of pool lift for your swimming pools. 

Leave a Reply

Your email address will not be published. Required fields are marked *